How to Install Rear Wiper
Installing a rear wiper on your vehicle can be a straightforward task, especially if you follow the right steps and have the necessary tools. Rear wipers are essential for maintaining visibility during rainy conditions, and having one can greatly enhance your driving experience. In this article, we will guide you through the process of installing a rear wiper on your car or truck.
Step 1: Gather the Necessary Tools and Materials
Before starting the installation process, gather the following tools and materials:
– Rear wiper arm
– Rear wiper blade
– Wiper motor (if necessary)
– Screwdriver
– Socket set (if the wiper motor is secured with bolts)
– Rags or paper towels
– Lubricant (such as WD-40)
Step 2: Park Your Vehicle on a Level Surface
Ensure that your vehicle is parked on a level surface to avoid any complications during the installation process. Engage the parking brake and turn off the engine.
Step 3: Locate the Rear Wiper Motor
Identify the rear wiper motor, which is typically located behind the rear window. The motor is connected to the wiper arm and blade. You may need to remove some interior panels or trim to access the motor.
Step 4: Disconnect the Wiper Motor
Using the appropriate screwdriver or socket set, disconnect the wiper motor from the vehicle’s electrical system. This may involve removing a few screws or clips. Once disconnected, set the motor aside for later reinstallation.
Step 5: Remove the Wiper Arm
Locate the retaining clip or bolt that holds the wiper arm in place. Depending on your vehicle, this may be a single bolt or a clip that requires prying. Remove the clip or bolt and set it aside.
Step 6: Install the New Wiper Arm
Attach the new rear wiper arm to the wiper motor. Ensure that the arm is aligned with the motor’s mounting bracket. Secure the arm in place using the retaining clip or bolt.
Step 7: Attach the Wiper Blade
Slide the new wiper blade onto the wiper arm. Ensure that the blade is properly seated and that it makes contact with the rear window.
Step 8: Reconnect the Wiper Motor
Reconnect the wiper motor to the vehicle’s electrical system. Tighten any screws or clips that were removed during the disconnection process.
Step 9: Test the Rear Wiper
Start your vehicle and test the rear wiper to ensure that it operates correctly. Adjust the wiper speed and timing if necessary. If the wiper does not function properly, double-check the connections and ensure that the blade is seated correctly.
Step 10: Clean Up and Dispose of Old Parts
Wipe down any excess lubricant or debris from the installation process. Dispose of the old wiper arm and blade according to your local recycling guidelines.
Congratulations! You have successfully installed a rear wiper on your vehicle. This addition will improve your visibility during rainy conditions and provide a safer driving experience.
