Step-by-Step Guide- How to Install a Door Knob Like a Pro

How to Install a Door Knob

Installing a door knob is a relatively simple task that can be completed in just a few steps. Whether you’re replacing an old, worn-out door knob or adding a new one to a new door, the process is straightforward and can be done by most homeowners without the need for professional assistance. In this article, we’ll guide you through the process of installing a door knob, from preparing the materials to completing the final touches.

Materials Needed

Before you begin, gather the following materials:

– Door knob kit (including the door knob, spindle, rose, and screws)
– Screwdriver
– Pliers
– Safety glasses
– Gloves

Step 1: Remove the Old Door Knob

Start by removing the old door knob. To do this, locate the set screws on the back of the rose and remove them with a screwdriver. Once the screws are out, gently pull the rose away from the door. Be sure to hold the door knob in place as you remove the rose to avoid damaging the door.

Step 2: Remove the Spindle

With the rose removed, you’ll see the spindle connecting the door knob to the latch. Use pliers to loosen the set screw on the back of the spindle and then pull the spindle out of the door.

Step 3: Install the New Rose

Hold the new rose over the door hole and align the mounting holes with the holes in the door. Insert the screws through the rose and into the door, then tighten them securely. Be sure the rose is flush with the door surface.

Step 4: Install the Spindle

Slide the new spindle through the rose and into the latch, making sure it’s properly seated. Tighten the set screw on the back of the spindle to secure it in place.

Step 5: Install the Door Knob

Attach the door knob to the spindle by aligning the set screws with the holes in the door knob. Use a screwdriver to tighten the screws, making sure the door knob is securely fastened.

Step 6: Test the Door Knob

Gently turn the door knob to ensure it operates smoothly. If the door knob is difficult to turn or doesn’t engage with the latch properly, double-check that the spindle is properly seated and that the screws are tight.

Step 7: Final Touches

Inspect the door knob to ensure that it’s aligned properly and that the rose is flush with the door. If necessary, adjust the door knob or the rose to achieve the desired look.

Congratulations! You’ve successfully installed a new door knob. This simple task can improve the appearance of your door and make it easier to open and close. With a bit of patience and the right tools, you can tackle this DIY project with confidence.